PPAP and APQP
For new parts and new programs

New parts go through our PPAP and APQP process, the advance planning and part approval steps your quality team asks a supplier for.
Request a quote
We design the fixtures, machine your parts and assemble them under one roof, from a single prototype to high production.
We take complete responsibility for your part. We source the castings and forgings through our global supply partners, machine them here in Lancaster and deliver finished parts or complete assemblies.
Request a quoteUpload a drawing or a 3D model of your part or assembly, with the quantities you need.
Our engineers design the fixtures and tooling for your part and plan its PPAP and APQP approval.
We machine your parts in small or high production lots and assemble them when you need the complete unit.
Our engineering group designs the tooling and the mechanical and hydraulic fixtures that hold your part in the machine, and helps simplify your design so it costs less to make.
Design for manufacture and assembly, rapid prototyping, automation and machine tool development, drawn in EdgeCAM, Solidworks and Pro-E.

We machine your prototype on 3, 4 and 5 axis CNC mills and lathes, then carry it into small or high production lots. With production assembly and electrical and mechanical integration in the same plant, you can buy a single machined part or the complete assembly from us.

Prototypes and reverse engineering, precision CNC milling and turning, small to high production lot sizes, production assembly, automation and global supply chain management.
Effective quality control is part of our commitment to meeting your expectations, so we use several methods to keep every part consistent.
For new parts and new programs

New parts go through our PPAP and APQP process, the advance planning and part approval steps your quality team asks a supplier for.
Request a quoteAt the machine, during the run

Parts are checked in station while the run is going, and we track the results with statistical process control (SPC).
Request a quoteMeasured against your drawing

Our quality lab checks parts against the dimensions and tolerances on your drawing, and our quality system follows ISO 9001:2015.
Request a quoteA few of the machined parts and components from our shop, in aluminum, copper and anodized finishes.

Triple clamp

Crankcase half

Copper cold plates

Heat sinks

Pocketed chassis

Lever arm

Anodized cover

Fly reels
Upload a drawing or a 3D model and tell us about your part, the quantities and your timing.